PROBLEM: When showing a user's avatar, it requires multiple clicks. Clicking "Show Avatar" will force the avatar back onto default shield settings, and displays the HUD message "Avatar will follow Safety Settings". After narrowing down the cause, I believe it may have to do with the avatar's performance being Very Poor. REPRO STEPS: Have User 1, be on mobile Android; User 2 can be on any platform. User 2 must wear an avatar that is uploaded to Quest/Android, and its counterpart must be Very Poor performance. User 1 should try to fully show User 2's avatar. If it goes through on the first try, then User 1 should try to hide the avatar, or revert to the avatar's default shield level settings (aka click the Shield). Then try fully showing the avatar again. User 1 might see a message when fully showing User 2, stating that the "Avatar will follow Safety Settings", while refusing to fully show User 2's avatar. OTHER ATTEMPTS: This bug did not occur when the user was wearing an optimized Public avatar, and did not occur when they were using an platform-incompatible [Impostor] avatar. Also attempted repro with the "Allow override with 'Show Avatar' setting disabled. SETTINGS: Shield Level configuration: 'Normal' Safety Shield. Avatar Main Menu Settings (in attached photo): [Block Poorly Optimized Avatars: Poor and Below] [Maximum Download Size: 10 MB] [Maximum Uncompressed Size: 25 MB] [Hide Avatars Beyond (Culling): Disabled] [Maximum Shown Avatars: 15] [Always Show Friend Avatars: Enabled] [Allow override with "Show Avatar": Enabled] I reproduced this bug with this feature both enabled and disabled, for due diligence Attached video showcasing this bug is at 2x speed, so I can fit the file on Canny.